Kia Rio: Heater Unit Components
| 1. Shower Duct (Left) 2. Heater Pipe Cover 3. Mode Control Actuator 4. Mode Control Actuator Bracket 5. Defog mode lever (FATC) 6. Mode Control Main Lever (MANUAL) 7. Vent Sub lever 8. Vent Door Lever |
9. Foot Sub Lever 10. Heat Case (Left) 11. Heater Core Assembly 12. Aspirator Hose 13.Temperature Control Actuator 14. Temperature Control Actuator Lever 15. Temperature Door Lever |
| 1. NVH Pad 2. Defog Seal 3. Vent Seal 4. Vent/Defog Door 5. Foot Door 6. Temperature Door 7. Evaporator Temperature Sensor Hole Cover 8. Evaporator Temperature Sensor 9. Heater Lower Case 10. Drain Hose |
11. Heater Case (Right) 12. Blower Resistor (MANUAL) 13. Power Mosfet (FATC) 14. Foot Actuator (With auto defogging system) 15. Cool Box Hose 16. Shower Duct (Left) 17. Flange Seal 18. Evaporator Flange Clip 19. Evaporator Core Cover 20. Evaporator Core |
Heater Unit ReplacementGeneral
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...
Thermostat: Installation
1.
Place the thermostat in the block.
Install the thermostat (B) with the jiggle valve upward.
2.
Install the water inlet fitting (A).
...
Delivery Pipe Installation
•
Do not use already used injector fixing clip again.
...
