Kia Rio: Installation
|
1. |
Install in the reverse order of removal.
Battery sensor cable installation
bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1
lb-ft)
Battery (-) terminal l tightening
nut: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3
lb-ft)
|
|
|
•
After reconnecting the battery negative cable,
AMS and ISG function does not operates until the system
is stabilized, about 4 hours.
If disconnecting the negative (-) battery cable
from the battery during repair work for the vehicle
equipped with ISG function, Battery sensor recalibration
procedure should be performed after finishing the repair
work. (Refer to Battery Sensor Recalibration Procedure)
|
|
•
For the vehicle equipped with a battery sensor,
be careful not to damage the battery sensor when the
battery is replaced or recharged.
|
| 1.
When replacing the battery, it should be same
one (type, capacity and brand) that is originally installed
on your vehicle. If a battery of a different type is
replaced, the battery sensor may recognize the battery
to be abnormal.
|
| 2.
When installing the ground cable on the negative
post of battery, tighten the clamp with specified torque.
An excessive tightening torque can damage the PCB internal
circuit and the battery terminal .
|
| 3.
When recharging the battery, ground the negative
terminal of the booster battery to the vehicle body.
|
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector.
3.
Remove the battery ...
1.
Check for DTCs.
•
If a DTC is ...
Removal
Inspection