Kia Rio: SS-B Solenoid Valve(ON/OFF) Removal

1.	Remove the battery and the battery tray. (Refer to "Charging system" in EE group.)

Remove the under cover (A).

Tightening torque:

6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.	Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug. (Refer to "Hydraulic system (Fluid)" in this group)

Remove the valve body cover (A) and eyebolt (B).

Tightening torque:

13.7 ~ 15.7 N.m (1.4 ~ 1.6 kgf.m, 10.1 ~ 11.6 lb-ft)

Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

Remove installation bolts in the engin room first and then remove others under the vehicle.

Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:

9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.	Remove the solenoid valve (B) after removing the solenoid support (A).

1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor ...

1. Installation is the reverse of removal. • When installing, ...