Kia Rio Manuals Rio Car Manuals
Technical Info

Kia Rio: Sub Frame Replacement - Front Suspension System - Suspension System - Kia Rio UB 2012-2020 Service ManualKia Rio: Sub Frame Replacement

1.
Remove the front wheel & tire.

Tightening torque :
88.3 ~ 107.9N.m(9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)



     
Be careful not to damage to the hub bolts when removing the front wheel & tire.
2.
Disconnect the stabilizer link (B) with the front strut assembly (A) after loosening the nut.

Tightening torque :
98.1 ~ 117.7N.m(10.0 ~ 12.0kgf.m, 72.3 ~ 86.8lb-ft)


3.
Loosen the nut and then remove the tie-rod end (A) with the front axle (B) by using SST(09568-34000).

Tightening torque :
23.5 ~ 33.3N.m(2.5 ~ 3.4kgf.m, 19.4 ~ 24.6lb-ft)



4.
Loosen the nut and then remove the lower arm (A).

Tightening torque :
58.8 ~ 70.6N.m(6.0 ~ 7.2kgf.m, 43.4 ~ 52.1lb-ft)


5.
Loosen the bolt (A) and then disconnect the universal joint assembly from the pinion of the steering gear box.

Tightening torque :
32.4 ~ 37.3N.m(3.3 ~ 3.8kgf.m, 23.9 ~ 27.5lb-ft)



     
Lock the steering wheel in the straight ahead position to prevent the damage of the clock spring inner cable when you handle the steering wheel.
Do not use the bolt again.
6.
Remove the rubber hanger (A).


7.
Loosening the roll rod (A) mounting bolts and nuts.

Tightening torque :
53.9 ~ 63.7N.m(5.5 ~ 6.5kgf.m, 39.8 ~ 47.0lb-ft)


8.
Loosen the bolts & nuts and then remove the front sub frame (A).

Tightening torque :
Sub frame mounting bolt & nut
156.9 ~ 176.5N.m(16.0 ~ 18.0kgf.m, 115.7 ~ 130.2lb-ft)
Sub frame stay mounting bolt
44.1 ~ 53.9N.m(4.5 ~ 5.5kgf.m, 32.5 ~ 39.8lb-ft)


9.
Installation is the reverse of removal.
Front Stabilizer Bar Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...
Rear Suspension System
...
See also:

Driver Airbag (DAB) Module and Clock Spring Removal
1. Set the front tires straight-ahead before removing the steering wheel.    ...

Component Location
1. Back view camera 2. AVN (AV & Navigation) head unit ...

Replacement
The injector combustion seal should be replaced new one to prevent leakage after removing the injector. 1. Remove the combustion seal (A) with a wire cutter. ...

Copyright © www.kiamanual.com 2020-2024 | Privacy Policy | Kia Car Parts